Analoge Loks mit Section Control/en: Unterschied zwischen den Versionen
Aus RailRoad&Co.-Wiki
Zur Navigation springenZur Suche springen
Uslex (Diskussion | Beiträge) Die Seite wurde neu angelegt: „If analogue locomotives, i.e. locomotives without a built-in decoder, are to be controlled with stationary decoders, i.e. decoders that are mounted on the track, the option '''Stationary block decoders''' must be activated in the Digital System dialog.“ |
Übernehme Bearbeitung einer neuen Version der Quellseite |
||
| (6 dazwischenliegende Versionen von 2 Benutzern werden nicht angezeigt) | |||
| Zeile 1: | Zeile 1: | ||
<languages/> | <languages/> | ||
{{ | {{TC91011gsb}} | ||
__NOTOC__ | __NOTOC__ | ||
| Zeile 21: | Zeile 21: | ||
If analogue locomotives, i.e. locomotives without a built-in decoder, are to be controlled with stationary decoders, i.e. decoders that are mounted on the track, the option '''Stationary block decoders''' must be activated in the Digital System dialog. | If analogue locomotives, i.e. locomotives without a built-in decoder, are to be controlled with stationary decoders, i.e. decoders that are mounted on the track, the option '''Stationary block decoders''' must be activated in the Digital System dialog. | ||
Only then will the settings with which stationary block decoders are set up in the program become visible on the user interface; this includes the Connection in the Block tab. | |||
== Weblinks == | |||
== Weblinks == | |||
*Source: [https://www.freiwald.com/forum/viewtopic.php?p=273316#p273316 Forum] | |||
* | *TC-wiki: [[Special:MyLanguage/Fahren + Signalisierung analog vs. digital (Grundlagen)|Driving + Signaling analogue vs. digital (basics)]] | ||
| Zeile 40: | Zeile 35: | ||
[[Kategorie: Software{{#translation:}}]] | [[Kategorie: Software{{#translation:}}]] | ||
[[Kategorie: Zugfahrt{{#translation:}}]] | [[Kategorie: Zugfahrt{{#translation:}}]] | ||
[[Kategorie: Analogmodus{{#translation:}}]] | |||
Aktuelle Version vom 12. November 2025, 14:15 Uhr
| Verwendung |
|
Driving analogue locomotives with Section Control
Connection missing in block editor
An analogue locomotive is to be controlled by means of decoders assigned to the track section.
In the block editor window the Connection tab is missing.
Stationary block decoders
- Mr. Freiwald describes in the forum:
If analogue locomotives, i.e. locomotives without a built-in decoder, are to be controlled with stationary decoders, i.e. decoders that are mounted on the track, the option Stationary block decoders must be activated in the Digital System dialog.
Only then will the settings with which stationary block decoders are set up in the program become visible on the user interface; this includes the Connection in the Block tab.
Weblinks
- Source: Forum
- TC-wiki: Driving + Signaling analogue vs. digital (basics)
- -- Uslex (Diskussion) 18:35, 27. Feb. 2025 (CET)
