Strom und Temperatur auslesen/en: Unterschied zwischen den Versionen
Uslex (Diskussion | Beiträge) Die Seite wurde neu angelegt: „The 3-digit temperature value must be divided by 10 for the display.“ |
Uslex (Diskussion | Beiträge) Die Seite wurde neu angelegt: „* Source: [https://www.freiwald.com/forum/viewtopic.php?p=281067#p281067 Forum] * TC-wiki: Z21; Caution when connecting the boosters 10806 and 10807 * TC-wiki: Roco Dual Booster over CAN-Bus“ |
||
| (3 dazwischenliegende Versionen desselben Benutzers werden nicht angezeigt) | |||
| Zeile 35: | Zeile 35: | ||
:[[Datei:Temperaturdurch10.png|400px]] | :[[Datei:Temperaturdurch10.png|400px]] | ||
: | :''Fig: Temperature divided by 10'' | ||
'' | |||
I have a signalman press the button every 3 seconds. This way, I always have a real-time view of the power consumption and temperature of the control unit, and I can also set limits and trigger further actions. | |||
== Weblinks == | == Weblinks == | ||
* Source: [https://www.freiwald.com/forum/viewtopic.php?p=281067#p281067 Forum] | |||
* | * TC-wiki: [[Special:MyLanguage/Z21; Achtung bei Anschluss der Booster 10806 und 10807|Z21; Caution when connecting the boosters 10806 and 10807]] | ||
* TC-wiki: [[Special:MyLanguage/Z21; Achtung bei Anschluss der Booster 10806 und 10807|Z21; | * TC-wiki: [[Special:MyLanguage/Roco Dual Booster über CAN-Bus|Roco Dual Booster over CAN-Bus]] | ||
* TC-wiki: [[Special:MyLanguage/Roco Dual Booster über CAN-Bus|Roco Dual Booster | |||
Aktuelle Version vom 27. Juli 2026, 13:25 Uhr
| Verwendung |
|
Read temperature, voltage and current
Monitoring during operation
I want to keep an eye on current, voltage, and temperature at the factory.
Can these values be queried directly from TC?
Booster Station
Silvio Richter describes in the forum:
The prerequisite is the Booster operating station and a block assigned to the operating station in the FDL.
A button assigned to this block is used as an operation to assign values to a numerical variable (context booster).
The current is read in mA, the temperature and voltage as a three-digit number.
The result could then look like this:
- fig: Booster-Strom
Divide variable by 10
The 3-digit temperature value must be divided by 10 for the display.
- Fig: Temperature divided by 10
I have a signalman press the button every 3 seconds. This way, I always have a real-time view of the power consumption and temperature of the control unit, and I can also set limits and trigger further actions.
Weblinks
- Source: Forum
- TC-wiki: Z21; Caution when connecting the boosters 10806 and 10807
- TC-wiki: Roco Dual Booster over CAN-Bus
- -- Uslex 12:39, 24. Jul. 2026
